For 23cm, use of the K6PYP repeater on 1282.575 MHz (PL=103.5) is suggested.
Until our 23cm repeater is operational, a link radio to the K6PYP repeater
will remain in place. There is also a one-way link from 70cm to 23cm
that may be active at times. Upgrading the controller firmware is
necessary before allowing proper two-way operation of the link.
On 2005/05/10, the UHF repeater suffered some damage. The antenna was
knocked down and the power amplifier failed. During 2006, the antenna was
replaced. On 2007/02/23, the power amplifier was returned by T.E. Systems
after repair and reinstalled. As required by FCC regulations, the power
output into the antenna feed line was measured to be 50 watts or less.
However, it is noted that there is no longer an RF path that will bypass the
power amplifier should it fail again.
This page last revised by
D. Stussy, KD6LVW, on 2007/02/24.